The MA5600T supports the SHDSL service of multiple encapsulation modes, such as IPoA, PPPoA, IPoE, and PPPoE.
Configure the SHDSL line profile.
To configure the SHDSL line profile, run the shdsl line-profile add or shdsl line-profile add command.
huawei(config)#shdsl line-profile quickadd 10 line two-wire rate 2048 2048 psd symmetric transmission Annex-A remote disable probe disable snr-margin ds-curr 10 ds-worst 10 us-curr 10 us-worst 10 bitmap 0x03
Configure the SHDSL alarm profile.
To configure the SHDSL alarm profile, run the shdsl alarm-profile add command.
In this example, the default profile (profile 1) is used.
Configure the SHDSL traffic profile.
You can configure the SHDSL traffic profile by running the traffic table command based on your requirements.
In this example, the default profile (profile 6) is used.
Activate the SHDSL port.
huawei(config)#interface shl 0/5
huawei(config-if-shdsl-0/5)#deactivate all
huawei(config-if-shdsl-0/5)#alarm-config all 1
huawei(config-if-shdsl-0/5)#activate all 10
huawei(config-if-shdsl-0/5)#quit
Configure the upstream port.
The SHDSL users of Huawei MA5680T adopt the PPPoE authentication. In this case, the smart VLAN is used to identify the users.
huawei(config)#vlan 1300 smart
huawei(config)#port vlan 1300 0/7 0-1
Add the service port.
Ports 0-31 in slot 0/5 provide the SHDSL service. To activate the ports in batches, run the multi-service-port command.
huawei(config)#multi-service-port vlan 1300 port 0/5 0-31 vpi 0 vci 35 rx-cttr 6 tx-cttr 6